Now Available Online
Same Day Dispatch
*Orders received before 12.30 pm will be shipped the same day
DERIVAN DRAWING FLUID & SCREEN BLOCK OUT
DERIVAN LIQUID STENCIL
Screen-printing with the new water-based Derivan Screen Printing Stencil System is a non-toxic process. Makes creating your hand-drawn prints a breeze. This straightforward process is ideal for all ages, perfect for the art studio, classroom or dining table.
GREAT FOR :
Screen printing t-shirts
Hand drawn designs
Printing on fabric
Printing on paper
HOW DOES SCREEN PRINTING WORK?
DOWNLOAD SAFETY DATA SHEET HERE - BLOCK OUT
DOWNLOAD SAFETY DATA SHEET HERE - DRAWING FLUID
Application
Use the drawing fluid with a brush onto the silkscreen to create a hand-painted design. Then apply the block out to the whole silk screen. The screen will last for many prints. Once you finish your print run you can remove the block out with soap and warm water leaving the screen clean and ready for your next design.
HOW TO CREATE YOUR HAND PAINTED STENCIL
How to produce a hand-painted stencil by hand onto a screen without any toxic photo emulsion
STEP 1
Draw your design onto a piece of white paper to use as a guide.
STEP 2
Reverse the image by either tracing the reverse side of the paper or by putting it in photoshop.
STEP 3
Place the design under the screen – TIP: make sure the design and the screen aren’t touching.
STEP 4
Trace the image using a brush, or for thinner lines use the nib on the bottle. Making sure to make the application is evenly applied. The thicker the medium, the longer the drying time..
STEP 5
Once you have finished this step leave to dry for approximately one hour or alternatively you can speed up the drying process with a fan heater or hairdryer.
STEP 6
Once the Resist Medium has dried thoroughly, you can now use the Block Out Medium with a squeegee to apply use one pass to spread a good layer across the screen. Make sure you have covered the whole screen.
STEP 7
Leave to dry for 48 hours - do not force dry
STEP 8
When the block out medium is dry - wash the screen with cold water on both sides, to remove your resist medium leaving your image in the negative on the screen.
STEP 9
Once again leave the screen to dry naturally – this is important – the Block Out Medium may take up some water – so it is imperative you leave the screen to dry again completely
STEP 10
You are now ready to screen print your design on to fabric, canvas or wood.
STEP 11
When finished printing use cold water to wash the ink out – do this before the ink has a chance to set in the screen (and so it is easy and quick to remove) and work reasonably quickly so as not to give the block out a chance to start to become soluble - as you need to be careful to not wash out the block out at the same time as the ink! – the block out should not start to dissolve for quite some time however if it does make sure all the ink is removed and then remove from water and put in a warm dry place to dry the block out again – do not use again until the block out is completely dry. Avoid rubbing the block out while washing out the ink – use a soft cloth but do not use brushes etc which will be more aggressive and more likely to remove the block out.
STEP 12
Once you are done with the design and wish to remove the block out Medium -use hot water and rub liquid soap into the block out and leave for 10 minutes to soak then use a soft brush to clean the block out our of the screen.
|
|